- #21 [wanny], 20-06-13 13:50thanks...all ching
- #22 [呀金], 20-06-13 13:53老年油污如果谷水唔得,可能都要用熱水同哥士的軟化一下先,再去谷水通。
- #23 [phil.ng], 20-06-13 14:58扭開隔氣丶清洗
留意隔氣到公家喉長度丶用通渠蛇丶入到公家位
之後再用水喉大量水充丶可能要再用蛇丶又再充水 -
- #24 [0925], 20-06-13 15:32
最後修改時間: 2020-06-13 15:32:13 - #25 [一縷輕煙], 20-06-13 15:34喉管油積並非懸浮,果種硬度相當高,通渠蛇就算過到樽頸位,條蛇有幾粗,只表示條喉個洞同一大小,谷水更是冇用之地,可能真係洗吓錢至得
不過用通渠蛇通吓都好過冇,慢但去到 - #26 [alexanderkoo], 20-06-13 15:59There may be design problem as mentioned. The conventional trap, overflow bottle type would hinder water flow. A U trap is more useful, just installed but in a hurry so no time to test. Cut an opening of 90mm dia on stainless steel for the basket was not easy. (more difficult to enlarge existing opening) Complete replacement of sink can be an option but existing one bonded by lots of cement. Should be undersink type but bad workmanship.
Replaced all external pipes by 50mm ones except through wall one.(using reducer at the area)
https://detail.tmall.com/item.htm?spm=a1z10.5-b.w4011-10388640720.68.5de32d22bgjDse&id=618630830863&rn=c8e6c7da1c158edc55daf8f86dfe3252&abbucket=1&skuId=4363579548921
Should have bought larger dia not 38mm, but of plastic material.
For clearing clog, simply use frayed(wired exposed to trap debris) TV coaxial cable and rotate whilst penetrating with water flowing slowly. All cleared via inspection hole.(village house) Could hear water trickling whilst in service. Almost for free. The above work is for improvement.
最後修改時間: 2020-06-13 16:06:42 - #27 [phil.ng], 20-06-13 15:59蛇用法是不停轉動丶我在外國用電蛇丶蛇在喉內不停亂轉丶要不時拉出又再入丶每次兩呎丶油積被打散
這才是正確做法
用過你就明丶不只是"插而不轉" - #28 [phil.ng], 20-06-13 16:02
Power snake
紙上談兵!冇用
手動會好攰
打散後要用水充走丶散油積
油是會被金钃蛇打散的
好太多丶可能要做多幾次
不信蛇的丶自己cut 條三尺二寸喉丶再用條短蛇接電鑚、你會清楚條蛇怎様"亂打"
最後修改時間: 2020-06-13 16:16:48 - #29 [Krell], 20-06-13 16:12有次浴缸去水慢,最後停埋去唔到。叫水喉佬嚟,攞咗兩支圖中武器,關埋門,攪咗十分八分鐘就通晒。雖然浴缸未必處理如星盤,俾你作個參考。
- #30 [alexanderkoo], 20-06-14 13:27Man she tak as #24 is much better. System must be filled with water and all openings covered by cloth, simulating a water tight system.
Spring or similar is not useful, tried initially and hard to go through bend.(larger pipes in other countries?) Then went for the coaxial cable, deep penetration. (sounds like AV) Freeing clog many times in last 2 decades, no failure rate. C Fu earned me no money.
HL drain point can interfere low level floor one due to hydraulic and pipe a bit clogged. Water spilling on floor when washer in pumping cycle. Individual pipes to the main drain pipe is desirable. Doing such mod.
Bought 32/40/50mm pipes and fittings from Taobao,very cheap, RMB 1 for fitting, RMB 8 for 1m 50mm pipe. But don't get too excited, pipe measured in OD, local one in ID. Insert a small pc first, simply mod.
最後修改時間: 2020-06-14 13:36:09 - #31 [phil.ng], 20-06-14 14:42外國/淘寶可能有
現今蛇頭進步了很多 - #32 [phil.ng], 20-06-14 14:58大细都有丶打散頭丶勾物頭
- #33 [phil.ng], 20-06-14 15:00轉灣頭丶有不同大細
- #34 [alexanderkoo], 20-06-14 15:36Should be soft to bend, small bending radius yet rigid enough to travel through the pipe without twisting itself.
- #35 [laplap], 20-06-14 16:38搵師父通過都系搞唔掂
去水超慢
不過條友吹水唔抹咀
又系賴屋外條喉塞左
我話你系大廈外面搵條喉比我睇下
再搵多兩個師父黎又系無得搞
最後修改時間: 2020-06-14 16:46:33 - #36 [phil.ng], 20-06-14 18:27又有高壓水jet 嘴丶好多専門公司都有用
街邊那些就!! - #37 [alexanderkoo], 20-06-14 18:53Caustic first, use washer to pump water to drain pipe, fill system with water and cover all openings by cloth, use hand pump(man shi tak) with water tap opened slightly. Must work for my kitchen. For other premises, design problem of kitchen sink and drainage, everything undersized and aged, so complete renewal.
Sometimes, mix detergent with hot water. - #38 [phil.ng], 20-06-15 19:01搞成點
如喉長丶用三丶四樽日本通渠水丶"食"一晚後開水試下
最後修改時間: 2020-06-15 19:05:36 - #39 [DeepSea^^], 20-06-15 19:26有朋友試過找師父都話外牆大喉塞了無得搞,我在大學實驗室拿了一杯完全無稀釋的14M硫酸,只用了一杯,5分鐘便一天光晒。
- #40 [joey], 20-06-15 19:31我都試過,用好長嘅彈弓去了,但係又唔見好多垃圾,
5金鋪話倒哥士的先去油污,廁所先用通渠佬落去
我未試過,唔知得唔得 - 下一頁 (2 of 15)
- 返回 ...