- #36 [thundersnow], 20-08-01 11:30
- #35 [lekin], 20-07-31 16:39鑽小孔,用鈎拉出,再補小孔
車門做法 - #34 [Howard1668], 20-07-31 16:24面頭有coating就大鑊....之前見到有對dyna...隻esotar 成隻手指模印..
呢d高音可以用一塊薄薄地既布好似眼鏡布之類..包住個吸咀..輕輕吸返平佢..
不過一定有摺痕...小心d就ok.. -
- #33 [terry00138], 20-07-31 15:52吸塵機吸返出嚟
- #32 [jeffreylam98], 20-07-31 14:24我問左喇,$800 一個,你會唔會可以自己整反出來啊
- #31 [hercules], 20-05-11 23:24雙面雙紙DIY, 因鎂本身硬,必有痕,但聲無事
- #30 [hercules], 20-05-11 23:23運送損壞純鎂高音,好硬
- #29 [louis9968], 20-05-10 07:10#27
我亦無言 - #28 [fotheringay], 20-05-09 23:21
Do you want to replace it due to there is obvious sign of deteriorated sound quality or just the look?
Most of the time it doesn't really affect the sound quality if the coil is still intact. Look is otherwise and most people just hate seeing it.
If you have cloth, paper or plastic dust cover then it ill normally be put back easily by tape or fine sewing needle, plus patience.
I did use very fine need to pierce through the metal dome and gently put it back from inside. It is a faint task and requires a few gentle touches. And more than likely it will not be 100% back in shape but still better than a badly dented dust cover.
BTW, when I read your title I thought you were talking about the old B&W CM1 from the 80's which I have.
最後修改時間: 2020-05-09 23:22:41 - #27 [254mm], 20-05-09 18:13如果拆到个高音出黎,装番d 線,正負对番一樣,事前影相先,如果咁都做唔到?無言
- #26 [normanlam], 20-05-09 14:51寶華都建議我先拆開睇吓識唔識自己換,如果無信心才交比佢哋換,收人工$700。
寶華維修個師傅都好客氣! - #25 [talkx2], 20-05-08 11:20既然8舊水成本咁低,我更會先DIY 試下先!
衰咗當交學費
不是悭幾百的問題,而是拆過見過分音,見過内部接線...之後你真的會懂多了喇叭從生産角度看是甚麽回事,以後揀喇叭知道那些是真技術,那些是吹水大口仔 - #24 [bcagl], 20-05-08 09:57$800 已有頗厚的利潤了
最後修改時間: 2020-05-08 10:11:49 - #23 [louis9968], 20-05-08 06:40抵, 換!
如果係 ProAc 就斬到一頸血!
最後修改時間: 2020-05-08 06:40:38 - #22 [normanlam], 20-05-07 22:03問咗寶華:一隻高音$800,自己更換。
- #21 [254mm], 20-05-07 15:07若一下子倒轉裝,正負銲片也反轉的
- #20 [normanlam], 20-05-06 12:42多謝#18嘅補充
- #19 [louis9968], 20-05-06 00:56都吾係穿,照用, 哈!
最後修改時間: 2020-05-06 00:58:04 - #18 [254mm], 20-05-06 00:13補充下#16, 拆四口羅絲時,要mark 个振膜片方向,我習慣用棉花捧推番順个 dome, 再用陰力旋轉條棉花捧,令效果更完美些,做好了,跟番原位(mark 左)装番个dome 膜。
- #17 [normanlam], 20-05-05 23:40OK!可以試吓!謝謝
- 下一頁 (1 of 2)
- 返回 ...
第一次凹咗真係好心痛,仲抬番去寶華換,之後第二丶三丶四。。。至N次後就麻木了。
小凹可以用強力膠紙慢慢拉番出嚟,凹得勁就可以好似上面師兄講,拆出嚟用綿花棒推番正佢。
除非你家中小朋友已長大,否則我建議你自己整,否則只會再次心痛。