- #10 [111], 22-05-27 20:34
- #9 [hahayanyan], 22-05-27 11:48平價囉機.. 應該內地牌"東成"比較可靠
- #8 [ckhung], 22-05-27 11:46謝謝#6師兄的提議, 我原先都有考慮過, 是成本最低的但我手勢一般, 之前試過開木板孔, 得電池鑽..有點吃力… TB黎計我見開邊機價位還可以, 唔係成日用應該諗得過
-
- #7 [hahayanyan], 22-05-27 11:38the potential problem of 木鈴梳......... as 倒相管 need very good matching diameter...if want tight fit..but not using a bit more of filling etc.. glue... haha
最後修改時間: 2022-05-27 11:40:40 - #6 [Baker.Steven], 22-05-27 11:35最簡單喺撐條一吋木方落個60mm孔度,買隻65mm木鈴梳,Mark中位鑽落去,平靚正
- #5 [hahayanyan], 22-05-27 11:35haah for that tube...u need to be quite precise ..haha
u have a router...usually for all DIY speaker maker...
all u need a template and a top bearing bit...
then it can be quite prefect outcome - #4 [ckhung], 22-05-27 11:28謝謝師兄, 非常詳細的解釋. 我剛才都諗到用修邊刀落手, 但未諗到師兄有定位的方法, 相對配合埋定位去做, 成件事便可更加完美了
- #3 [hahayanyan], 22-05-27 11:21using this type of router bit..and cost about rmb 30 ( top bearing type )
- #2 [hahayanyan], 22-05-27 11:04
Pretty way 去淘寶made一塊65mm內徑嘅5mm厚亞加力板 as a template, and then a 喺淘寶買一個 200蚊嘅wood router.withtop bearing bit. 你明白上面講乜你就會知道細節應該點做
將以下嘅木板換成一塊正確嘅 亞加力導向板
U may find a 65mm hole saw.. Too
There are easy way to fix a centre position too
最後修改時間: 2022-05-27 11:18:36 - #1 [ckhung], 22-05-27 11:00原開孔60mm要變做65mm, 冇鑽床有咩做法好?
- 返回 ...
我唔知你有無用過 router(大鑼機)或 trimmer(修邊機)?
如沒學習用過,頗為危險,由其是router, 手指都可以無埋
就算trimmer, 如落刀太深,肯定會"拍"一聲,嚇親你