- #498 [0925], 24-05-04 18:14
- #497 [new68u], 24-05-04 17:12類似呢啲可以成塊拎起嚟洗
- #496 [new68u], 24-05-04 17:08#495 留意最好買個內蓋可以唔駛工具就拆得,否則可能好易收藏污糟嘢
-
- #495 [0925], 24-05-04 16:43#494 + 1
ABS 外殼
內層 316,外層304,如果 3-ply 中間夹鋁效果可能好啲
826g 頗重
最少煮兩嘜米,試煮一嘜落多咗水
比想像中易清潔
最後修改時間: 2024-05-04 16:56:47 - #494 [0925], 24-05-01 18:07#492 + 1
老婆拼多多找到賣 ¥196 的,如果316內膽的唔係賣得咁平,我就拎 #492 個304內膽去日本城配電飯煲。
最後修改時間: 2024-05-01 18:14:45 - #493 [lym], 24-05-01 16:21>>超市貼紙換的電飯煲個內膽花咕咗
咁黑仔?不過也無需太在意,個D cheapy 野,吾花都極可能用一兩下就花。 304 煮飯會有D黐,湯水燜燉個D無問題。 - #492 [0925], 24-05-01 16:18用超市貼紙換的電飯煲用幾年后個內膽花咗,¥38 買咗個 304 不鏽鋼的。
直徑和高度冇問題,304 個底太平
電飯煲個 heater plate 有個彎位
拆出來睇下可唔可以磨平個彎位
結論:要磨低差不多 1 cm 同條內藏發熱線好接近,就算用得熱力都不均勻,唔搞喇。
剛淘咗一個 316 不鏽鋼內膽的電飯煲,不過 3L 的大好多(2L 的衹有304內膽的)
最後修改時間: 2024-05-01 16:33:23 - #491 [0925], 24-04-26 13:05
最後修改時間: 2024-04-26 13:06:09 - #490 [0925], 24-04-17 07:18
- #489 [0925], 24-04-14 18:11
最後修改時間: 2024-04-14 18:12:33 - #488 [alexanderkoo], 24-04-14 10:07Panasonic water flosser having leaky tubing. Dissemble the handle and cut the faulty tube by a few inches. Two small holding tabs and spring fall apart. Take time to figure out how to put them back for holding the flosser tip.
For waterpik, can buy replica handle with tubing on Taobao.
最後修改時間: 2024-04-14 10:08:25 - #487 [alexanderkoo], 24-04-13 07:17早四個月前裝的一匹冷氣機,天氣熱再度電流,正常,沒有漏雪種,舊機重用,這個拑表,專為冷氣而設,很好用,可度起動電容數值,但電流4A,再上400A,無言,可度出風溫度(駁線有正負方向,熱偶原理,颇準)反而鐳射槍顯示多種温度
最後修改時間: 2024-04-13 07:19:03 - #486 [alexanderkoo], 24-04-13 07:06買了解凍板,有點用,食材-0.2C,室溫25.1C,
- #485 [0925], 24-04-11 23:31
- #484 [0925], 24-04-08 13:17
- #483 [alexanderkoo], 24-04-06 07:30Water spray doesn't work, only lamp illumination. Open it up and there is voltage at motor. Dissemble the pump and motor. The latter can run. Pump problem. Got a complete unit at $22. Parts kept as spare, Outer casing dumped
最後修改時間: 2024-04-06 07:32:12 - #482 [alexanderkoo], 24-04-04 06:45New copper tube sensor is of short cable length suitable for AC. Dried out the original one, it's 5k, potted by epoxy and re-used. Can buy longer length 0.5 or 1m. Or simply old cable+new sensor with joints.
When AC can run for a while as if it were normal, with cooling, then tripped with flashing light. It's usually this sensor problem due to water ingress. If icing at coil, leaking refrigerant causing sensor to trip. So, sensor is normal.
最後修改時間: 2024-04-04 07:00:48 - #481 [呀金], 24-04-04 03:07第二部。
- #480 [泰tai], 24-04-04 02:06屋企樓下回收執到
- #479 [泰tai], 24-04-04 02:04癈物利用,改造個隨身吸(改造中)鑽牆好幫手
- 下一頁 (2 of 26)
- 返回 ...
最後修改時間: 2024-05-04 18:14:47