- #61 [nana111], 14-06-20 12:10
- #62 [布朗.], 14-06-20 12:16早兩日叫日立師傅睇我廳部小涼伴
佢溫度計度出風口溫度係11度....但我問200呎廳裝兩匹,點解完全唔涼
我關左左右送風,廳想溫一個位好凍的...都無
師傅左度右度,話計埋廚房和睡房走廊...有三百幾呎...咁當然唔凍...
我真係頂佢個掣....咁多理由...所以唔建議各位買小涼伴.
其實我上手業主房都係小涼伴,都係要開到好盡 - #63 [alexanderkoo], 14-06-20 13:41Not simply temp, air flow rate(volume of air in terms of CFM or cubic metre/sec) is also important. Can feel the coolness(chill) at least 3 ft away. More prof C-fu would also measure the flow rate by anemometer.
-
- #64 [nana111], 14-06-20 14:01possibly get a gree 1hp with remote, HKD2.3k all included. If go for Pan need 1k more.BTW remote control useful or not? all I can think of is to set sleeper time.
- #65 [S6410], 14-06-20 14:18Hitachi quiet but not cool.
Panasonic OK cold but not the quietest..
Gree VERY cold but not quiet, especially have strange "water flow" sound.
Midea/Fortress OK cold but heard story getting rather noisy after using for a few years.
Conclusion is to go for either Panasonic or Gree (or Gree OEM).
Hitachi a big no no as your room will get very hot in the midst of summer days. Quiet but you can sleep sweating? - #66 [armic], 14-06-20 14:23布朗.
你200呎廳用幾多匹??
我都用緊小涼伴,廳都叫剛好(可能有恆溫),但客房扭4-5會超凍
但我都唔見意買小涼伴,用料差左.... - #67 [布朗.], 14-06-21 00:31我小涼伴用兩匹,我外母屋企用格力,凍到似北極。
- #68 [nana111], 14-06-21 13:28見到有三菱電機一匹窗口機,有冇師兄用过?
- #69 [bigapple28], 14-06-22 00:31#68 三菱電機, 我用緊, 2005買到依家, 3/4 用在100呎房, 較7-8 (Max10)已夠凍, 9年機從末洗過維修過, 仍操作正常及夠凍
- #70 [S6410], 14-06-22 01:15菱機 is not Mitsubishi...Just OEMed by Gree and markets by the HK dealer of Mitsubishi...
Yes as cold as Gree but don't expect it as quiet as Hitachi/Panasonic... - #71 [wbam], 14-06-23 17:30今年裝左部菱機兩匹, $4200, 搖控型號.
部機真係唔算靜. 我個廳220呎左右, 今年最熱個幾日開都OK涼, 好過之前部樂聲. - #72 [柳飄飄], 14-06-23 17:36菱機一級能源標籤
- #73 [254mm], 14-06-23 18:00我最近裝了 1 匹半的 LittleSwan, 及 1 匹的 LittleSwan, 都算靜, 好平, 美的代理 1 匹 $1900, 1 匹半 $2550 包普通安裝
- #74 [254mm], 14-06-23 21:23靜過用開的豐澤多多聲, 舊的匹半嘈到拆天, 而家舒服多矣, 我指雙耳, 估唔到 LittleSwan 一級能源, 平靚正靜
- #75 [alexanderkoo], 14-06-24 09:26Fortress=Midea years ago. Room cooler tends to be more quiet when new.(of course, there are exceptions) Would be noisy after 2-3 years due to aging(especially anti-vibration pads of compressor) and corrosion.(loosened fan pedestal support, corroded fan cowl(not the blade itself but the fixed portion) at the back)
- #76 [ben0301], 14-06-25 02:53我住響大陸, 分體機的話美的真係買唔過, 我用過兩部:
第一部係我住果度既房東既, 我搬入去果陣都已經唔係新機, 最熱果段時間開到盡再將風口set到對正自己吹都只係勉強夠凍
第二部係我office既變頻機, 我個office係頂樓, 夏天特別熱, 部機新買番黎頭兩年都好夠凍, 第三年開始要將設定溫度調低先得, 然後制冷能力逐年下降, 調到最低溫再將自己個位搬到冷氣機正下方, 將風口對正自己吹我都仲不停流汗
以上兩部機, 洗完都唔會有乜改善, 搵人check雪種又正常, 部機既工作電流亦都係正常範圍內........以後真係有人送俾我都唔會要 - #77 [alexanderkoo], 14-06-25 10:25C-fu would fill the refrigerant on the low side(even 50psi for R22 !! customer being cheated without noticing), unless he comes on a hot summer day. Hence, more accurate in filling.(R22, around 65 psi at 30 C outdoor) If topping up say at 25 C, 60 psi, it's likely that the pressure would be high on hot day,hence excessive current.(overloading) I did assist to top up my building's common area split unit for free, it's cool but current was slightly on high side.(should be OK when it leaked after a few months, overcharging a bit is good practice) Releasing refrigerant a bit is easy(using a screwdriver to press the schrader valve/3 way valve) but topping up needs more work/equipment.
Split type is more durable(except inverter unit, electronics vulnerable to failure) than window unit, perhaps due to less corrosion.(no accumulation of pool of water in the chassis) Don't think the design of compressor would make a difference. Stainless steel chassis for window unit is stillborn.
最後修改時間: 2014-06-25 10:27:32 - #78 [hk2046], 14-06-25 11:43點解 實惠樂富店 格力3/4hk1580 特然咁平 24062014攝
- #79 [ef9], 14-06-25 11:52請問,2匹/2匹半有邊部好推介,
用左落聲 6-7年,百零2百尺到,就算新裝時 客飯廳好多時吾係甘夠凍,起碼要開2個鐘到先覺冇甘熱,尼2年開始明顯吾凍
嘈音越來越大
大牌子計 那款好D
TH㐅 - #80 [smoons], 14-06-25 12:13如果大约 6~10年前買嘅冷氣机 到現在都夠凍, 唔代表現在買翻同一亇牌子就ok,因製做已不及當年喇
- 下一頁 (4 of 26)
- 返回 ...
I am shopping for new air con as well.
Thanks
最後修改時間: 2014-06-20 12:10:55